|
Navigation: Toolboxes > Mechatronics Toolbox > Servo Motor Editor > Data Files > Tecnotion 2006 |
  
|
20-sim 3.6\Tools\Servo Motor Dynamics\Tecnotion 2006.cse
November 2006
www.tecnotion.com
The data file Tecnotion 2006.cse contains the complete set of Tecnotion motors, program 2006. Most of the data has been extracted from the Tecnotion data sheets. The tables below shows the 20-sim names and the corresponding data sheet names. Some parameters were not available in the data sheets and have been given by the Tecnotion motor company. These parameters are indicated as Given by Tecnotion. Some parameters were calculated. These are indicated as Calculated.
Important: The nominal data and the default value of the thermal resistance RT2 are calculated for air cooling. The value for RT2 can be changed using a slider. If water cooling is used, change the value of RT2 to its minimum value.
|
Servo Motor Editor |
Tecnotion Data Sheets |
|
General Data |
|
|
Name Keyname Info Type Date Price Delivery Time Library |
Motor Series Order Number Additional Information AC Synchronous Linear 21 October 2005 - - Tecnotion 2006.cse |
|
Nominal Data |
|
|
Force Current Speed Voltage Power |
Continuous Force (air cooled*) Continuous Current (air cooled*) 0 m/s Calculated - |
|
Max/Peak Data |
|
|
Force Current Power Voltage Speed |
Ultimate Force / Peak Force Ultimate Current / Peak Current Calculated Max. voltage ph-ph Maximum speed |
|
Thermal Data |
|
|
Temp_amb Temp_initial Temp_max RT1 RT2 CT1 CT2 |
Set to 25 Set to 25 Maximum Temperature Thermal Resistance coil - housing Calculated* Given by Tecnotion Given by Tecnotion |
|
Physical Data |
|
|
F_axial F_Radial m D_motor L_motor D_shaft L_shaft |
- - - - - - - |
|
Electrical Data |
|
|
R L alpha_c Ktc Pitch |
2 * Resistance per phase 2 * Induction per phase 0.004 0 Magnet Pitch NN |
|
Mechanical Data |
|
|
m_motor d F_fric F_cog |
Weight of Coilunit Given by Tecnotion - 0 |
|
Derived Data |
|
|
K_nom K_max S_nom P_dis |
Calculated Calculated Calculated Calculated |
* Note: The nominal data and the default value of the thermal resistance RT2 are calculated for air cooling. The value for RT2 can be changed using a slider. If water cooling is used, change the value of RT2 to its minimum value.